Desa V)CD36RN - Manual (Page 29)

www.desatech.com 116035-01E 9
FIREPLACE
INSTALLATION
Continued
PRESSURE TESTING FIREPLACE GAS
CONNECTIONS
1. Open equipment shutoff valve (see Figure 52,
page 28).
2. Open propane/LP supply tank valve for
propane/LP fireplace or main gas valve
located on or near gas meter for natural gas
fireplace.
3. Make sure control knob of fireplace is in the
OFF position.
4. Check all joints from equipment shutoff valve
to gas valve (see Figure 53 for propane/LP or
Figure 54 for natural gas). Apply noncorrosive
leak detection fluid to all joints. Bubbles form-
ing show a leak. Correct all leaks at once.
5. Light fireplace (see Operating Fireplace, page
31). Check all other internal joints for leaks.
6. Turn off fireplace (see To Turn Off Gas to Ap-
pliance, page 32 or 35 depending on model).
REMOvING/REPLACING GLASS
DOOR
CAUTION: Do not operate
this fireplace with a broken glass
door panel or without the glass
door panel securely in place.
For replacement part informa-
tion see Replacement Parts,
page 44.
CAUTION: Wear gloves and
safety glasses while handling
or removing broken glass. Do
not remove if glass is hot. Keep
children and pets away from
glass.
WARNING: If fireplace has
been running, turn off and un-
plug fireplace. Let cool before re-
moving glass door or louvers.
Removing Lower Louver Access Panel
1. Grasp the lower louver panel and pull up until
the hanger brackets release from the door pins
(see Figure 55).
Figure 55 - Removing Lower Louver
Access Panel
Door Pin
Hanger Bracket
Lower Louver
Access Panel
2. Swing the louver panel out until it clears the
fireplace opening.
3. Pull the entire panel out until the bottom tabs
are free of the slot openings in the lower face
frame.
Figure 56 - Removing Top Louver Trim
Panel
Panel Tabs
Top Louver
Trim Panel
Door Pin
Hanger
Bracket
Removing Top Louver Trim Panel
1. Grasp the two hanger brackets at the bottom
and pull up until the hanger brackets release
from the door pins (see Figure 56).
2. Swing out the bracket ends until the upper
panel tabs can be angled out of the slot open-
ings in the upper face frame.
3. Pull the entire louver trim panel out of the face
frame.