Dodge 2008 Sprinter - Manual (Page 341)

339
Operation
Battery isolating switch*
4
̈ Take the key out of the ignition lock
and wait for approximately
20 seconds.
̈ Move red slide 2 down in the direc-
tion of the arrow and disconnect
connector 1 from the ground pin.
̈ Clamp connector 1 under the ac-
celerator pedal so that it cannot
make contact with the ground pin.
The consumers of the vehicle battery
are cut off from the electrical circuit.
! CAUTION
Make sure that the key is in
position 0 in the ignition lock and
wait at least 20 seconds before dis-
connecting or connecting the battery
isolating switch. You could otherwise
damage electrical system compo-
nents.
Switching off the electrical system ! CAUTION
When you clamp the connector under
the accelerator pedal, make sure that
the connector does not become:
ț dirty
ț damaged
It may otherwise not be possible to
restore the electrical connection
when the parts are reassembled.
nf_BA.book Page 339 Friday, January 25, 2008 3:53 PM