Denso BHT-6000 - Manual (Page 37)

22
(1) Selecting the memory area to be initialized
Press the PW key while holding down the SF ,
M1 and 0 keys together.
The screen shown at left will appear.
1 ALL : Initializes both the flash ROM (ex-
cept for its system area) and RAM.
This should be chosen when you
first power on the BHT-6000 from
the time of purchase.
2 DRIVE A : Initializes the RAM only.
3 DRIVE B : Initializes the flash ROM only (ex-
cept for its system area).
Select a desired item by using the numerical keys,
then press the ENT key.
If the message "System error! Contact
your administrator. Note the error drive.
(DRIVE A)" appears on the LCD, select
"2: DRIVE A" to initialize the RAM.
If the message "System error! .....
(DRIVE B)" appears, select "3: DRIVE
B" to initialize the flash ROM.
REFERENCE
(2) Confirming the memory area selected for initialization
INITIALIZE
1:ALL
2:DRIVE A
3:DRIVE B
INITIALIZE
(ALL)
OK ?
1:Yes
2:No
Selecting the memory area in step (1) above will
call up the confirmation screen shown at left where
you check the selected memory area on the 2nd
line.
1 Yes : Shifts to the message version selection
screen before executing initialization.
2 No : Cancels initialization and turns the power
off.
Select a desired item by using the numerical keys,
then press the ENT key.
To return to the previous screen, press the C key.