Denso BHT-6000 - Manual (Page 31)

16
2.4 Preparation
2.4.1 Setting-up 1: Loading Dry Batteries or Battery
Cartridge
Before the first use of the BHT-6000, be sure to load dry batteries or battery cartridge
as shown below. Dry batteries or battery cartridge is not loaded in the BHT-6000 when
shipped from the factory.
Loading dry batteries
(1) Turn the BHT-6000 upside down.
(2) As shown below, slide the battery cover lock in the direction of the arrow and
remove the battery cover.
(3) Check the polarity (positive and negative) of two new LR03 batteries and load
them.
(4) Put the battery cover back into place taking care not to pinch the battery pull strap
between its cover and the bottom cover. Then, return the battery cover lock to its
original position.
Loading the battery cartridge
To use the battery cartridge, you need to remove the dry battery support from the
BHT-6000 and replace the battery cover with the battery cartridge cover (sold
separately). The battery cartridge cover has an opening for charge terminals.
NOTE
(1) Charge the Ni-MH battery cartridge, referring to Section 5.5, “Charging the Ni-MH
Battery Cartridge.”
(2) Turn the BHT-6000 upside down.
+
-
+
-
Battery pull strap
Battery cover
Battery cover lock
Dry battery support
Battery
cartridge
cover
Battery
cover