Aiwa CSD-ED 57 - Manual (Page 4)

7 Press *RADIO/BAND repeatedly to select the
desired band.
j—¥ FM —^ AM —I
The power is turned on and the previously tuned
station is received.
The RADIO indicator lights up.
* or BAND on the remote control when the AC cord is
connected (except CSD-ED37)
2
Press (+, - TUNING) to select a
station. ^^
During FM stereo reception, iSTEREOl is displayed.
After listening, press POWER (!) STANDBY to turn the
power off.
For better reception
%
FM
NOTE
If the unit picks up noise from other electrical appliances
nearby, like a TV or fluorescent lights, move the unit.
PRESETTING STATIONS
You can preset up to 15 stations in each band.
7 Select a station.
2
Press *■ STOP/MEMORY once so that “M” is
displayed to store the station.
A station is assigned a preset number, beginning from 1
in consecutive order for each band.
“M” may not be displayed if the button is kept pressed for
more than 0.5 second.
Preset number
t
3/i
ISlij
mo-
Extend the FM antenna and The AM antenna is inside
orient it for the best reception. the unit. Position the unit
for the best reception.
For quick tuning
Keep +, — TUNING pressed until the tuner starts
searching for a station. When a station is tuned to, the
search stops.
If the broadcast signal is weak, it does not stop. To stop
the search manually, press + or —.
*REPEAT/FM MODE/OSC
- If an FM stereo broadcast contains noise, press the
button so that IMONOI is displayed.
Noise is reduced, although reception is monaural.
To restore stereo reception, press the button again.
- If a high-pitched sound is heard during AM recording,
press the button repeatedly until the noise is reduced. Its
position can be checked by being on or off the display.
* or MODE on the remote control (except CSD-ED37)
To change the AM tuning interval
The default setting of the AM tuning interval is 10 kFIz/step.
If you use this unit in an area where the frequency
allocation system is 9 kFIz/step, change the interval as
follows.
1 Press RADIO/BAND to display FM.
2 Press ■ while pressing RADIO/BAND to display the
AM frequency.
When the AM tuning interval is changed, the preset
stations are cleared.
4 ENGLISH
Frequency
* or ■ on the remote control (except CSD-ED37)
3
Repeat steps 1 and 2.
The next station will not be stored if a total of 15 preset
stations have already been stored for a band.
To listen to preset stations
Select a band then press ►!! PLAY/PAUSE/PRESET
repeatedly.
► PLAY on the remote control is also available.
To select a preset number directly with the remote
control (except CSD-ED37)
Press the numbered buttons 0-9 and -i-IO.
Example:
To select number 15, press +10 and 5.
To select number 10, press +10 and 0.
To clear a preset station
Display the preset number first. Then, press ■ while the
preset number is displayed.
The higher numbers in the band are decreased by one.