Q-See QSDT8PCRC - Manual (Page 5)

SuperDVR & QSDT8PCRC Cards
User Manual
Error! Use the Home tab to apply
标题 标题 标题 标题 1 to the text that you want to
appear here. Error! Use the Home
tab to apply 标题 标题 标题 标题 1 to the text that
you want to appear here.
5
1
Introduction
1.1 Summarization
Thank you for choosing our digital video capture cards.
The QSDT8PCRC 8 Channel cards use software H.264 compression format, and
enable a maximum of 16 channels real-time surveillance in CIF resolution. Our
cards are mature and cost-effective products that should be your ideal choices.
They enable synchronous audio and video compression and transmission along
with their powerful compression rate and network transmission function. They are
widely used in banks, intelligent communities, traffic management units, medical
systems, educational systems, armed forces and so on.
This manual is suitable for SuperDVR 6.3, which supports QSDT8PCRC
cards.
In this manual, you will learn how to install the hardware and driver (software),
and how to setup the systems on this range of products. Please make sure
your operations with the products are strictly in accordance with the manual,
to maintain the stability of the digital surveillance systems.
The following are standard functions of these products:
• Schedule record mode
Users can choose any period in a day to record and set up record modes,
i.e. sensor alarm record, motion detection record, manual record,
Schedule Record.
• Motion detection mode
Motion detection areas are adjustable with a maximum 16 areas for each
channel. Users can also set motion detection sensitivity for each channel.
The system begins to record only when motion is detected is detected on
the channel and after motion stops it will stop recording after a certain time
period, which is adjustable by users.
• Sensor alarm record mode
The system has an external alarm which enables the system to support
alarm input and output.
• Recycling record mode
Users can set recording storage sequence for HDD partitions. The
recording storage will automatically switch to the next partition when the
current one is full. If all the partitions are full and recycling record mode is
enabled, the oldest recorded data will be covered by new data. Users can
also set HDD minimum storage alarm. Then once the present storage
space is less then the minimum storage and recycling record mode is not