Q-See QSDT8PCRC - Manual (Page 30)

Error! Use the Home tab to apply
标题
标题 标题 标题 1 to the text that you want to
appear here.
Error! Use the Home
tab to apply 标题 标题 标题 标题 1 to the text that
you want to appear here.
SuperDVR & QSDT8PCRC
User Manual
30
HDD space shortage alarm.
1. Video Loss
Users can select alarm output for this option. For example, users select
alarm_out1 and alarm_out3 for video loss. Then video loss of any channel will
trigger alarm_out1, alarm_out3 to show a red light in the Alarm output status
panel (refer to Figure4-6 for reference to this panel).
2. Disk Alarm
When HDD available space is less than the set value (see Figure5-9), it will
trigger alarm.
3. Sensor
Sensor 1: If users have mounted sensors, when the sensors have been
activated, it will trigger the selected output alarms.
Sensor 2 - Sensor 16: Two QSPD4116 cards have a maximum of 16 sensors.
4. Motion
Motion 1: Users can set the output of motion detection alarm by different
alarms and remote alarm.
Motion 2 - Motion 16: 32CH card has maximum 16 motion alarms.
NOTICE: You should choose our additional alarm device board while
using two QSPD4116 cards for alarm I/O.
5.5.4 Auto Mail Function
Users can select the above-mentioned alarms to be output by Auto Mail.
NOTICE: Before you setup this function, make sure the DVR is set to
Motion Recording.
Click ‘ Auto Mail’ icon on the left top side of alarm configuration page to enter
the following area to make Auto Mail setup, refer to Figure5-12.