Q-See QSDT8PCRC User Manual
Page 20
Error! Use the Home tab to apply
标题
标题
标题
标题 1 to the text that you want to
appear here.
Error! Use the Home
tab to apply
标题
标题
标题
标题 1 to the text that
you want to appear here.
SuperDVR & QSDT8PCRC
User Manual
20
•
Red light: Sensor Alarm Record State
•
Blue light: Video Loss State
When the indicator light color turns into red
in row two, it means there is
an alarm output.
4.3.4 Manual Record Mode
Manual Record mode is the most commonly used recording mode. If a
special event occurs, users can select this recording mode and record
immediately.
NOTICE: You can select a high frame rate for a short time manual
recording, while selecting a low frame rate for long time Scheduled
Record.
4.3.5 Sensor Alarm Record Mode
Users can use sensors to trigger sensor alarm recording on relative channels.
At that time, the record status indicator light will turn red
.
4.3.6 Motion Detection Record Mode
This will enable the system to detect image changes and begin to record by
activating motion detection and motion alarm recording. For instance,
somebody opens the door, and the system detects image changes from the
camera and begins to record, then users can play back the recorded file and
find out who opened the door. When there is no movement, the system will
not record which saves system resources, and makes it easier to find
recorded events. The indicator light color in the record status panel will be
yellow
.
NOTICE: Users need to setup parameters in three places to enable
motion detection recording.
•
Select ‘Motion Detection’ for desired channels in ‘Basic
Configuration’.
•
Configure the motion detection areas for desired channels in
‘Motion Detection Configuration’.
•
Configure working schedule for desired channels in ‘Schedule
Configuration’.