Aiwa CSD-SL15 - Manual (Page 4)

FUNCTION-
o.
QSOUND■
BASS-
VOLUME■
—
CD OPERATIC
J
1
2
Set FUNCTION to CD.
Press CD OPEN to open the disc
compartment and place a disc with the
printed side down on the disc compartment
lid.
NOTE - Do not place smaller than 3-inch (8 cm) discs.
CD OPEN
3
4
The total number of tracks is displayed.
“1 ” indicates the 1 st track, and "• 1 ” indicates the 11 th
track. “1” and a fiashing indicate the 21st, 31st...
91st track.
Press ►!! PLAY/PAUSE to start play.
The number of the track being played is dispiayed.
Turn VOLUME and BASS to adjust the sound.
■ STOP - Stops play.
►II PLAY/PAUSE - Pauses play. To resume play, press
again.
N◄,►►1 SKIP/SEARCH - Searches for a particular point
during playback. Keep or ►►! pressed and then
release it.
- Skips to the beginning of a track. Press or ►>!
repeatedly.
REPEAT - Repeats a single track or all tracks. Select as
follows.
The REPEAT indicator flashes: A single track is played
repeatedly. Select a track with or ►►!.
The REPEAT indicator lights up: All tracks are played
repeatedly.
NOTE
• Do not use irregular shape CDs (example: heart-shaped,
octagonal ones).
It may result in malfunctions.
• Do not place more than one disc in the disc
compartment.
• Do not try to open the disc compartment during play.
• Do not touch the lens. Doing so may cause malfunctions.
TUNER OPERATIO
J
“i
Set FUNCTION to RADIO.
2
Select a band with BAND.
3
Tune to a station with TUNING.
4
Turn VOLUME and BASS to adjust the sound.
For better reception
Extend the FM antenna and
orient it for the best reception. The AM antenna is inside
the unit. Position the unit
for the best reception.
Rear
FM MODE/OSC
FM MODE/OSC
- Sets the FM sound to stereo or monaural.
STEREO: Reception is stereo.
MONO: When an FM stereo broadcast contains noise, set
to MONO. Noise is reduced, although reception is
monaural.
- If a high-pitched sound is heard during recording from
AM, set this switch to another position.
NOTE
If the unit picks up noise from other electrical appliances
nearby, like a TV or fluorescent lights, move the unit away.
GENERAL
I
To turn off the unit, set FUNCTION to 6 STANDBY
POWER so that the OPE/BATT indicator goes out.
To listen with the headphones, connect headphones with
a stereo mini plug to the 0 (Headphones) jack.
QSOUND system
This system provides a rich, three dimensional sound area.
You can enjoy a more enhanced sound.
Press QSOUND.
• At higher volumes, turning QSOUND on may cause sound
distortion. In this case, turn the volume down.
4 ENGLISH