Power supply, Important, Using on ac house currant – Aiwa CSD-SL15 User Manual

Page 3: Connect the ac cord as illustrated below, Caution, Using on batteries, The batteries need to be replaced when, Notes on batteries, Maintenance, To clean the heads and tape paths

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Power Supply

FUNCTION

OPE/BATT

IMPORTANT

Make sure that FUNCTION is set to 6 STANDBY POWER/

TAPE before connecting the AC cord or inserting batteries.

Using on AC house currant

Connect the AC cord as illustrated below.

CAUTION

Use oniy the supplied AC cord. Use with other cords may

result in the risk of fire.

Using on batteries

Open the lid of the battery compartment on the rear and
insert eight R14 (size C) batteries, not supplied, with the O

and

marks correctly aligned. Then close the lid.

To switch from AC power supply to battery power
supply, disconnect the AC cord from the AC inlet.

The batteries need to be replaced when:

The OPE/BATT indicator becomes dim, the tape speed
slows down, volume decreases, or sound is distorted during
operation.

Notes on batteries

• Do not mix different types of batteries or old batteries with

new ones.

• When the unit is not to be used for a long period, remove

the batteries to prevent needless battery wear.

• Never recharge the batteries, apply heat to them or take

them apart.

• Remove dead batteries.

If liquid leaks from the batteries, wipe thoroughly to remove.

Maintenance

To clean the cabinet

Use a soft cloth lightly moistened with mild detergent

solution. Do not use strong solvents such as alcohol,
benzine or thinner.

To clean the heads and tape
paths
After every 10 hours of use,
clean the heads

and ©, the

or denatured alcohol.

To clean the lens

Use a cotton swab slightly
moistened with cleaning fluid.

Wipe gently from the center to

the edge.

Lens

ENGLISH 3