Basic operation, Loading discs, Playing discs – Aiwa CX-NA222 User Manual
Page 10: To play all discs in the disc compartment, press, To play one disc only, press disc direct play 1-3, To check the remaining time, Selecting a track with the remote control, Replacing discs during play, 1 press disc change, Basic operations
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
CD PLAYING
BASIC OPERATION
CD EDIT CHECK
LOADING DISCS
Press CD, then press ± OPEN/CLOSE to open the
disc compartment. Load disc(s) with the label side
up.
To play one or two discs,
place the discs on tray 1 and 2.
To play three discs,
press
DISC CHANGE
to rotate the trays
after placing two discs. Place the third disc on tray 3.
Close the disc compartment by pressing ±
OPEN/CLOSE.
Tray
Tray number of the
disc to be played
■I
i i :
: I i ■
i !•■"
I
Total number of
tracks
Total playing time
PLAYING DISCS
Load discs.
To play all discs in the disc compartment, press
Play begins with the disc on tray 1.
i
I
Number of track
being played
Elapsed playing
time
To Play one disc only, press DISC DIRECT PLAY 1-3.
The selected disc is played once.
To stop play,
press ■.
To pause play,
press
II.
To resume play, press again.
To search for a particular point during playback,
keep
or ►► pressed and release it at the desired point.
To skip to the beginning of a track during playback,
press
◄◄ or ►► repeatedly or turn
MULTI JOG.
To remove discs,
press ±
OPEN/CLOSE.
To start play when the power is off (Direct Play Function)
Press
CD.
The power is turned on and play of the leaded disc(s)
begins.
When ±
OPEN/CLOSE
is pressed, the power is also turned on
and the disc compartment is opened.
To check the remaining time
During play, press
CD EDiT/CHECK
while pressing
SHIFT
on
the remote control. The amount of time remaining until all tracks
finish playing is displayed. To restore the playing time display,
repeat the above.
Selecting a track with the remote control
1
Press
DISC DIRECT PLAY 1-3
to select a disc.
2
Press numbered buttons
0-9
and
+10
to select a track.
Example:
To select the 25th track, press
+10, +10
and
5.
To select the 10th track, press
+10
and
0.
The selected track starts to play and continues to the end of
that disc.
Replacing discs during play
While one disc is playing, the other discs can be replaced without
interrupting play.
1
Press
DISC CHANGE.
2
Remove the discs and replace with other discs.
3
Press
A OPEN/CLOSE
to close the disc compartment.
• When loading an 8-cm (3-inch) disc, put it onto the inner circle
of the tray.
• Do not place more than one compact disc on one disc tray.
• Do not tilt the unit with discs loaded. Doing so may cause
malfunctions.
• Do not use irregular shape CDs (example: heart-shaped,
octagonal ones). It may result in malfunctions.
10
ENGLISH