Electrical connection, Mobile home installation – Avanti GR-20 User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
In order to avoid property damage or serious personal injury, never use a lighted match.
If a leak is present, tighten joint or unscrew, apply more joint compound, tighten again
and retest connection for leak.
Electrical Connection
•
Electrical connection must be made in accordance with local codes or in absence of
local codes, with the National Electrical Code, ANSMNFPA No.70-Latest Edition.
•
Connect the 2-prong supply cord to a 120-voIt, 60 Hz, 2-prong wall receptacle.
•
Electrical connection must not interfere with gas connection. (See“lnstallation
Requirements" Page 6)
Warning
Improper use of the grounded plug can result in a risk of electrical shock. If the power
cord is damaged have it replaced by an authorized Avanti Products service center.
> Mobile Home Installation
The installation of this range must conform with the Manufactured Home construction and
Safety Standard, Title 24 CFR, Part 3280 {formerly the Federal Standard for Mobile Home
Construction and Safety, Title 24, HUD (Part 280)} or. when such standard is not applicable, the
Standard for Manufactured Home Installations, ANSI A 225.1 and Manufactured Home
Installations, Sites, and Communities ANSI/NFPA 501 A, or with local codes.
When this range is installed in a mobile home, it must be secured to the floor during transit. Any
method of securing the range is adequate as long as it conforms to the standards listed above.
Copies of the standards may be obtained from:
*National Fire Protection Association
Batterymarch Park
Quincy, MA 02269
*American Gas Association
1515 Wilson Blvd.
Arlington, VA 22209