Leveling of range, Backguard installation, Warning – Avanti GR-20 User Manual
Page 6: Fig. 1 fig. 2
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
INSTALLATION OF YOUR GAS RANGE
A
WARNING
HAVE THIS RANGE INSTALLED BY A QUALIFIED INSTALLER.
Improper installation, adjustment, alteration, services, or
maintenance can cause injury or property damage. Consult a
qualified installer, service agency or the gas supplier.
^ Leveling of Range
The range must be level to obtain proper cooking results. The screwed leveling legs located on
the corner brackets at the bottom of range should be adjusted by turning them clockwise to
make the range higher or counter-clockwise to lower the range until the range is level
(See Figure 1). Use a level on the cookware supports to check the leveling of the range.
HIGHER
LOWER
Fig. 1
Fig. 2
Backguard Installation
•
Place the backguard on top of the cooktop at the rear of the range (Figure 2)
•
Line up the holes on the backguard with the holes on cooktop.
•
Fasten the backguard to cooktop by using the screws, washers and nuts supplied with
the range.
A
WARNING
- ALL RANGES
CAN TIP
• INJURY TO PERSONS
COULD RESULT
• INSTALL ANTi'TIP
DEVICES PACKED
WITH RANGE
• SEE INSTALLATION
INSTRUCTIONS