Avanti GR-20 - Manual (Page 15)

Conversion of Oven Burner
• Unplug the main supply cord of the range.
• Open oven door.
• Remove the bottom panel of oven pushing it backwards, then lifting
the front edge up and out as shown in Figure 17.
• Loosen the screw which holds the burner in place, and remove the
burner completely (See Figure 18)
• Loosen and remove the orifice at the bottom rear of oven using a
7mm-spanner socket. Replace the orifice supplied with the range.
For the mark of orifice, see Table 1.
• Loosen the retaining screw on the burner ring, if setting for LP-
Propane gas operation, slide the ring towards the burner to open the
burner hole completely. In the factory setting for Natural Gas
operation, the ring must be located in a place that maintains a gap of
4 mm. (See Figure 19)
• Replace the burner in the oven and replace the screw. Replace the
bottom panel of oven.
• Keep the remaining orifice in its plastic bag for future use.
r^^l]
^ _____
■1
Fig. 17
Conversion of Broiling Burner (Model DGR-21A)
• Unplug the main supply cord of the range.
• Remove the screw and washer holding the burner in place (See
Figure 20).
• Pull out the burner until it releases.
• Remove the orifice using a 7mm-spanner socket. Replace the orifice
supplied with the range. For the mark of orifice, see Table 1.
• Replace the burner and the guard in the oven. Replace the washer
and tighten the screw. Be sure that the burner sits completely in
place while doing this.
• Keep the remaining orifice in its plastic bag for future use.
Fig. 19