Avanti GR-20 - Manual (Page 10)

There is a symbol over the knob on control panel in order to identify which knob
controls which burner. Also, there is a symbol indicator on the knobs, to aid in
setting the burner to the desired temperature.
To Light a Desired Surface Burner
• Push the control knob in.
• After the burner ignites, turn the knob counterclockwise without releasing it to adjust the
flame size. Then release the knob.
• For maximum heat output, align the large flame symbol on the knob with the vertical line
on the control panel. In order to decrease the heat output, turn the knob in the direction of
the small flame symbol. For minimum heat output, align the small flame symbol on the
knob with the vertical line on the control panel.
• The amount of food being cooked, the amount of liquid, or the size of the pan should
determine the heat settings. Always position the utensil on the burner grate before
lighting the burner. For your safety, the flame should not extend beyond the sides of the
pan.
• To turn the burner off, turn the knob clockwise until it reaches the (•) symbol.
The oven is controlled by a knob located at left side of control
panel. (See Figures 9&10)
This knob has two functions.
■ To control oven burner. (GR-20 and DGR-21A)
■ To control broiling burner. (DGR-21A ONLY)
When the knob is turned in a counterclockwise direction, it controls the oven. When the
knob is turned in the clockwise direction, the broiler is engaged. Those burners do not
run simultaneously.
The oven burner is controlled by a thermostat and has a flame failure device. The
numbers on the knob indicate the temperature in the center of oven cavity in degrees of
Fahrenheit.
lO