Avanti GR-20 - Manual (Page 16)

PROBLEMS WITH YOUR APPLIANCE?
You can solve many common appliance problems easily, saving you the cost of a possible service call.
Try the suggestions below to see if you can solve the problem before calling the servicer.
TROUBLESHOOTING GUIDE
FIND YOUR PROBLEM HERE POSSIBLE CAUSE HOW TO FIX IT
Surface burners do not light Surface control has not been
completely turned to the LITE
position.
Burner ports are clogged.
Burners not positioned
properly.
Range not set for appropriate
gas input
- Push in and turn control to the
LITE position until burner ignites,
then turn control to desired flame
setting.
- Use a small gauge wire or needle
to open parts.
- Verify that the burners are
positioned properly on the orifice
hoods and the burners are sitting
flat on the burner support with tabs
engaged in slots.
- See range conversion section of
Range power cord is
disconnected from the outlet.
this manual.
- Be sure power cord is plugged
into grounded outlet.
Flame burns halfway round. Burner ports are clogged.
Moisture is present after
cleaning.
Range is not set for appropriate
gas input
Use a small gauge wire or
needle to open ports.
Lightly fan the flame and allow
burner to operate until flame is
full, or dry burners thoroughly
following instructions in range
"Cleaning” section.
See range conversion section
of this manual.
Flame is orange. Dust particles in main line.
Range is not set for
appropriate gas input
- Allow burner to operate for a
few minutes until flame turns blue.
- See range conversion section of
this manual.
Oven light does not work. Burned out or loose bulb. - Tighten or replace oven light
bulb. (DGR-21Aonly)
16