Bolens 131-410A - Manual (Page 7)

BATTERY INFORMATION
A.
B.
C.
I WARNING ^
Battery acid must be handled with great care
as it wili biister the skin and damage clothing.
It is advisable to wear goggles, rubber gloves,
and a protective apron when working with it.
If for any reason acid should be spattered in
the eyes, wash it out immediately with clean
cold water. Seek medical aid if discomfort con­
tinues.
If acid gets on ciothes, dilute it with clean
water first, then neutralize with dilute ammonia
water or a water solution of baking soda.
D. Since battery acid is corrosive to metals, do
not pour into any sink or drain. Rinse empty
electrolyte containers and mutilate before
discarding.
E. Keep sparks, flame, cigarettes away.
F. Hydrogen gas is generated during charging
and discharging.
G. Ventilate when charging or using in enclosed
space.
H. When using a charger—to avoid sparks,
NEVER connect or disconnect charger clips to
battery while charger is turned on.
I. Always shield eyes, protect skin and clothing
when working near batteries.
t DANGER
j
BATTERIES CONTAIN SULFURIC
ACID AND MAY CONTAIN EXPLO­
SIVE GASES (when electrolyte has
been added).
Battery
Acid
Pack
Filling
Adapter
•
/
Hardware
/
N
Drain
Tube
ACTIVATING AND INSTALLING THE BATTERY
1. Upon opening the battery pack, you should
receive acid pack, battery, drain tube, filling
------adapter and hardware. See figure 8.
®
\
DANGER
\
BATTERIES CONTAIN SULFURIC
ACID AND MAY CONTAIN EXPLO­
SIVE GASES (when electrolyte has
been added).
FIGURE 8.
Manifold on
Battery
Clear Plastic
Drain Tube
2. Place the battery on table or workbench to be
filled.
3. Place one end of clear plastic drain tube on
— manifold of battery. See figure 9.
NOTE
Some batteries may already have
the drain tube installed, in which
case it may be necessary to snip off
the sealed end.
FIGURE 9.