SINGER W4910 Euroflair - Manual (Page 35)

Sewing with flatlock
Flatlock
Check that the needle is in the highest position. Turn
the stitch selector to the symbol CVS2VW and the stitch
length dial to the blue area.
To sew an overlapping seam, lap one piece of fabric
1 cm (%") over the other piece and sew with the flatlock
stitch over the fabric edge on the right side. Trim on the
wrong side or sew another seam from the right side.
You can produce a decorative hem by folding a single
hem on the wrong side and sewing the flatlock from the
right side.
Fasten binding by folding the binding over the edge of
the fabric, slightly wider on the wrong side. Sew over the
edge of the binding on the right side with the flatlock and
trim excess material. Use knit trim or bias binding when
binding curved edges, like round necks and armholes.
Use the flatlock to sew narrow belts, bands, etc. Fold
the fabric in three and sew in the center. Trim excess
material from underneath.
Flatlock is used for sewing overlapping seams, decora­
tive hems, binding and edges on woven and elastic
fabrics.
33