Blindstitching – SINGER W4910 Euroflair User Manual

Page 29

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Blindstitching

Blindstitching has small zig-zag stitches between the

larger zig-zag stitches. It is used for hemming skirts made
of woven and knitted fabrics without the stitches being

visible on the right side.

Check that the needle is in the highest position. Set the

stitch selector at the symbol

A/WVWW.

Set the stitch length dial at 1.5 as a recommended basic

setting, but you can reduce or increase the stitch length if

you wish to vary the space between the fastening
stitches.

To avoid hard creasing when hemming certain fabrics,

you can reduce the presser foot pressure one or two
steps.

Before starting to sew, it is wise to switch to half

speed. Test sew on a scrap of fabric and look at the right
side.

The thicker and softer the fabric, the less visible the

stitches will be. When sewing lightweight woven fabrics,
it is unavoidable that a small stitch will show on the right
side.

Fold the fabric as illustrated.