SINGER W4910 Euroflair User Manual

Page 17

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Changing the needle and presser foot

Changing the needle

Even if the needles look alike there can be slight

variations which can affect the sewing result. Be sure to
use high quality needles.

Only a completely undamaged needle will give perfect

sewing results. Therefore, change the needle if you have
the slightest reason to believe that it is bent or that the
point is damaged. To remove the needle, loosen the
screw in the needle clamp. With the flat side of the shank
away from you, insert the new needle into the needle

socket as far as it will go. Tighten the screw with the
screwdriver.

Changing the presser foot

If you wish to change the presser foot, check that the

needle is at its upper position. Remove the presser foot
by drawing it toward you while pressing slighly down

ward.

Insert the new presser foot in such a way that the

round, horizontal pin fits in between the spring and the

presser foot ankle. Press slightly downward and back
ward and the foot will snap into place.