beautypg.com

Troubleshooting – Sears 917.254710 User Manual

Page 27

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

TROUBLESHOOTING

PROBLEM

CAUSE / REMEDY (SEE INDEX!

WILL NOT START

Fin Tank with Gasoline, Check Fuel Une and Carburetor

{cleerr if necessary}. Replace Fuel Filter Use Fresh Fuel

Recharge or replace Battery
Check mring
Replace Spark Plugis) artd adjust gap

Drain and replace oil for proper temperature

WILL NOT TURN OVER

Push Clmch/Brake Pedal into brake position
Charge or replace Battery

Move Attachment dutch lever to "DISENGAGED”position
Replace Ignition Switch
Replace Interlock Switch fes}
Replace Solenoid or Starter

Replace Spark Plugis}
Replace Fuse
Check all Wire Connections and “Ground " Points

ENGINE CLICKS BUT WON'T START

Clean Battery Terminais
Replace Starter or Solenoid

Charge or Replace Battery
Check Wire Connections and ''Ground" Points

HARD TO START

Place Throttle Control In “FAST”position and run

starter several times w clear out gas

Remove Air Filter and dean
Replace Sperk Plugis} and adjust gap
Recharge or replace Battery
Check the Wring
Drain Fuel Tank end Carburetor. Use Fresh Fuel,

Replace Fuel Filter

Make necessary adjustments to Carburetor

Major Engine Overhaul

ENGINE MISSES OR LACKS POWER

Shift to a lomr gear or reduce had
Drain Gas Tank and Carhuretor. Usa Fresh Fuel
Remove and dean Air Cleaner

Make necessary carburetor adjustments
Clean Air Screen
Add or change all
Replace Spark Plugfs} and adjust gap

Replace Fuel Filter
Major Engine Overhaul

ENGINE OVERHEATS

Shift to lower gear or reduce load

Clean Air Screen

Add or change oil
Clean Engine Cooling Fins

Remove and dean Muffler or replace

Remove and dean Air Filter

Use fresh fuel and adjust Carburetor

NO LIGHTS

Check Fuse, Switch end Wire Connections- Replace

Headlight Bulbs

Replace Switch

CHARGE

Cheek Fuse for fault and replace
Replace Battery
Reptece Diode Assembly

Repteee Alterna ter

OPERATOR PRESENCE SYSTEM WILL NOT
SHUT DOWN ENGINE WHEN OPERATOR LEAVES
SEAT

NOTE:

This

tmetor

is

equipped

with

êP

Opmilor

presence

sensing systm. Any attempt by the apemtur to feavs the *№f

wkh

the

engine

rvnning

end

the

ettachmsnt

dutch

engaged

will shut down the engine.

Engage Attachment Clutch

Check ell Wire Connections
Check Seat Switch

27