L/rcrwjmi, L%jlv – Sears 917.254710 User Manual
Page 15
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

4
Mowing Tips
NOTE: TIRE CHAINS CANNOT BE USED WITH THE
MOWER HOUSING ATTACHED,
L/rCrwjMi
I
l%Jlv
HEAD THE "SAFETY RULES" CAREFULLY
BEFORE OPERATING YOUR MOWER.
REFER TO PAGE 2.
a, Use the runner on the R.H. side as в guidei the blade
cuts approximateiy an inch outside the runner {Fig,
b. Drive so that clippings ere discharged onto the area
that has been cut Have the cut area to the right of
the machine. This will result in a more even distri
bution of clippings and more uniform cutting.
c - When mpwirtg large areas (Fig. 16). start by turning
to the right so that the clippings will discharge away
from shrubs, fences, driveways, etc. After one or
two rounds, mow in the opposite direction making
left hand tome until finished.
d. if grass is extremely tali, it should be mowed twice.
The first time cut relatively high; the second time
to the desired height
в. The left hand side of mower should be used for
trimming,
S, Operating The Tractor On HUia
A
DO NOT DRIVE UP OR DOWN HILLS WITH
SLOPES GREATER THAN IS® AND DO
NOT DRIVE ACROSS ANY SLOPE. REFER
.TQ.mSE^-'L___________________________
a. Move gear shift taver to "t ST" gear before starting
up or down hills,
b. AVOID STOPPING OR SHIFTING ON HILLS,
c. If slowing Is necessary, move throttle control lever
to slower position.
A
LEAVE ENOUGH ROOM WHEN STOP
PING AMD STARTING TO ALLOW SLIGHT
tractor
roll
DOWNHILL AS CLUTCH/
BRAKE PEDAL MOVES THROUGH CLUTCH
POSITION.
^________ ___
d. If stopping is absoiutaiy necessary, push clutch/brake
pedal quickly to brake position and engage parking
brake.
6. Flip- Up Discharge Guard
Your mower has a fUp-up discharge guard (Fig, 1B) for
door or gate cieetance whan held in raised position.
A
MAKE SURE ATTACHMENT CLUTCH
LEVER IS IN "DISENGAGED" POSJTDN
AND BLADES HAVE STOPPED BEFORE
RAISING DISCHARGE GUARD (DEFLEC
TOR).
NEVER
OPERATE
MOWER
WITHOUT
DISCHARGE
GUARD
IN
OPERATING POSITION. ____
To restart tractor movement, make sure tractor Is in
the iowest speed range {1st Gear) end that you have
allowed room to roll slightly downhill. Depress
clutch/brake fuHy. Disengage parking brake and
release clutch/brake pedal SLOWLY to start tractor
movement.
f. Make all turns gradually.
15