Sears 113.23615 User Manual
Page 9
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
2; Use a small square to set the table at 90' to the blade.
Itthere is too much space between the square and the
blade, the table must be adjusted.
3. When the space between the square and the blade is
minimal, tighten the bevel lock knob. The table should
now be approximately 90” to the blade.
4. Loosen the screw holding the bevel scate pointer and
adjust to 0*. Tighten screw.
Remember, the bevel scate is a convenient guide but
should not be relied upon for precision.
Make practice cuts in scrap wood to determine it your
angle settings are correct. Adjust the table as required.
Bevel
Pointer