Sears 113.23615 - Manual (Page 24)

IMPORTANT
Supplement for Model 113.236150
Keep this sheet with your owner’s manual for future reference
This sheet supplements the owner's manual packed with your scroll saw. Tie instructions and illustrations shown on
this supplement should be followed whenever changing blades.
Refer to your variable speed 16 in scroll saw owner’s manual for safety instructions and proper use of the scroll saw.
Removing and installing Blades
WARNING: To avoid injury from accidental starting,
alvrays turn switch "OFF" and unpiug power cord
from outlet before removing or replacing the blade.
NOTE: Saw comes set up for pin end blades. If you are
going to use plain end blades, refer to the instructions
under “Installing Plain End Blades”,
Removing Pin End Blades
1 .Unplug power cord from outlet and check that switch is
off.
2. Loosen tension on blade by turning tension knob coun­
terclockwise about three full turns.
3. Remove blade from the tower blade holder by pushing
down on the upper arm, releasing the blade/pin from
the tower blade holder. Remove blade from the upper
blade holder by slightly lifting up on the blade and pull­
ing forward.
.......................