Sears 113.23615 - Manual (Page 13)

Mounting the Scroll Saw to a Bench-
1. When mounting this saw to a workbench a solid
wood bench is preferred over a plywood bench
where noise and vibration will be more noticeable.
2. Hardware to mount this saw to a workbench is Not
supplied with the saw. However, we recommend the
hardware used be not smaller than the following.
Description Qty.
Hex Head Screw, 1/4-20 x length required..................3
Flat Washers, 1/4 I.D................................................... 6
Lock Washers, 1/4 I.D................................................. 3
Hex Nuts. 1/4-20.......................................................... 6
3. A soft foam pad to place between your scroll saw and
workbench is NOT supplied with the saw. However,
we highly recommend the use of such a pad to
reduce noise and vibration.
Description Qty.
Soft foam pad such as carpet padding,
24” X 12" X 1/2"...................................................... 1
Do NOT over tighten mounting bolts - leave some cush­
ion in the foam pad for absorbing noise and vibration.
If you prefer to mount your saw to a leg set, we rec­
ommend the leg set for bench top tools which is
available through Sears Retail Stores. The number of
this leg set is 9-22244. This leg set is an optional
accessory and instructions to mount the scroll saw to
this leg set are included in the leg set package.
13