Sears 831.15403 - Manual (Page 20)

56. Wrap the Press Cable (69) around a 90mm
Pulley (39). Attach the Pulley, two Half Finger
Guards (42), a Small Cable Trap (48). and an
M10 Washer (116) to the Left Upright (5) with an
M10 X 108mm Bolt (99), an M10 Washer (116),
and an M10 Nylon Locknut (114). Make sure the
Cable Trap and Finger Guards are oriented as
shown.
57. Wrap the Press Cable (69) around a 90mm
Pulley (39). Attach the Pulley, two Half Finger
Guards (42), a Small Cable Trap (48), and an
M10 Washer (116) to the Press Frame (13) with
an Ml 0
X 135mm Bolt (98). Make sure the Cable
Trap and Finger Guards are oriented as
shown.
58. Wrap the Press Cable (69) around a “V”-pulley
(40). Attach the “V”-pulley, two Half Finger Guards
(42), a Cable Trap (49), and an Ml 0 Washer
(116) to the Left Upright (5) with an M10 x 68mm
Bolt (93) and an M10 Nylon Locknut (114).
Make
sure the Cable Trap and Finger Guards are
oriented as shown.
59. Wrap the Press Cable (69) around a 90mm
Pulley (39). Attach the Pulley, two Half Finger
Guards (42), a Small Cable Trap (48), and an
M10 Washer (116) to the Press Frame (13) with
the M10 X 135mm Bolt (98) used in step 57 and
an M10 Nylon Locknut (114). Make sure the
Cable Trap and Finger Guards are oriented as
shown.
60. Wrap the Press Cable (69) under a 90mm Pulley
(39). Attach the Pulley, two MIO Washers (116),
and two Half Finger Guards (42) to the Left Base
(2) with an M10 X 52mm Bolt (102) and an MIO
Nylon Locknut (114). Make sure the Finger
Guards are oriented as shown.
42 114
39 AV
20