Sears LIFESTULER SYSTEM 40 831.15931 - Manual (Page 9)

18. Attach a VKR Armrest (58) to each VKR Arm
(57) with two 1/4"
X
2* Screws (9) and 1/4*
Washers (1).
Attach the VKR Backrest (59) to the Rear
Upright (74) with two 1/4* x 21/2* Screws (2)
and 1/4* Washers (1).
19. Press a 1* Round Inner Cap (11) into each
end of a Handle (52).
Insert the end of the Handle (52) that has a
hole through it into the left VKR Arm (57).
Slide a 5/16* Washer (10) onto a 5/16" x 2"
Bolt (12). Insert the Bolt through the VKR
Arm and the Handle. Slide another 5/16"
Washer (10) onto the Bolt and tighten a 5/16"
Nylock Nut (4) onto the Bolt.
Assemble a Handle (52) to the right VKR Arm
(57) in the same manner.
20. Press a 1 1/2* X 1 1/2* Inner Cap (95) into the
Seat Frame (67) Attach the Seat Plate (68)
to the Seat Frame with the 1/4" x 2" Carriage
Bolt (25), a 1/4" Washer (1) and a 1/4" Nylock
Nut (23).
Attach the Seat (77) to the Seat Plate (68)
with two 1/4*
X
3/4* Screws (24).
Attach the Seat (77) to the Seat Frame (67)
with a 1/4* X 2* Screw (9) and 1/4“ Washer (1).
21. Attach the Seat Frame (67) to the Front
Upright (76) with two 5/16* x 2 3/4" Bolts (3).
5/16* Washers (10) and 5/16" Nylock Nuts
(4).
Press a 3/4" Round Inner Cap (30) into each
end of a Pad Tube (66).
insert the Pad Tube (66) into the Se^ Frame
(67). Center the Pad Tube and slide a 6* Foam
Pad (^) onto each end of it.
9