Sears LIFESTULER SYSTEM 40 831.15931 - Manual (Page 14)

37. Slide the end of the Long Cable (93) onto the
end of the 3/8* x 3 1/2* Bolt (5) in the Top
Brace (86). Slide a 3/8* Washer (8) onto the
Bolt and tighten the 3/8* Jam Nut (7) onto the
Bolt. Note: The 3/8" x 31/2" Bolt (5) Is the
Bolt that was used In assembly step 24.
The Bolt will already have one Nut thr^d-
ed onto It. The step described above will
attach the Long Cable to the remaining
threads so there will be two Nuts on the
Bolt.
38. Slide the Leg Press Plate (70) cxito the end of
the Leg Press Frame (72). Insert the 7“ *L"
Pin (40) through the Leg Press Plate and one
of the four holes in the Leg Press Frame.
39. Find the lower ends of the two Weight Guides
(83) (there are holes near the upper ends of
the Weight Guides). Slide a Weight Bumper
(50) onto the lower end of each Weight
Guide. Insert the Weight Guides into the
bracket on the Base (69).
Fit the Weight Guides (83) into the recesses
in the sides of the Weight (79) on the Weight
Selector (82).
40. Insert a 5/16* x 4 1/4* Bolt (41) through the
upper end of one of the Weight Guides (83).
Slide a 2 5/8" Metal Spacer (42) onto the Bolt
and insert the Bolt into the Top Brace (86).
Tighten a 6/16* Nylock Nut (4) onto the Bolt.
Attach the other Weight Guide (83) to the Top
Brace (86) in the same manner. ‘
14
37
Attach the Cable to
the same Bolt that
r ' ' was used in
assembly step 24
« I il t i n » '
38
39
40