Sears LIFESTULER SYSTEM 40 831.15931 - Manual (Page 10)

22, Attach the Backrest (78) to the Front Upright
(76) with two 1/4" X 2 1/2* Screws (2) and
1/4* Washers (1).
23. Insert a 3/8* x 2 3/4* Bolt (16) into one side of
the Top Brace (86). Slide a 3/8* x 3/8" Metal
Spacer (6) onto the Bolt. Lay the ball-end of
the Short Cable (94) over a 31/2"Pulley (55).
Slide the Pulley and another 3/8* x 3/8* Metal
Spacer (6) onto the Bolt, Insert the Bolt
through the ottier side of the Top Brace and
tighten a 3/8* Nylock Nut (15) onto the Bolt.
Attach the 2* Metal Spacer (49) inside the
Top Brace (86) with a 5/16* x 2 3/4" Bolt (3)
and 5/16* Nylock Nut (4). Make sure that the
Short Cable (94) is under the 2* Metal Spacer.
24. Insert the other end of the Short Cable (94)
» J tm .M l ^ jM mml Mk4 AI m Mk K m mm jmt. I m m A M •«% 3 mm m m .
u iw iwp wi u io ui aorvok wt i u ic i wp
(86) and the Front Upright (76). Lay the Cable
over a 3 1/2* Pulley (55). Hold the Pulley in
the upper end of the Front Upright.
Slide a 3/8* Washer (8) and 3/8" x 3/8" Metal
Spacer (6) onto a 3/8" x 3 1/2" Bolt (5). Insert
the Bolt through the Top Brace (86), Front
Upright (76) and 3 1/2" Pulley (55). Slide
another 3/8’^x 3/8" Metal Spacer (6) and 3/8"
Washer (8) onto the Bolt and tighten a 3/8“
Jam Nut (7) onto the Bolt.
Tighten all Nylock Nuts used In assembly
steps 4-5.
25. Attach two.3 1/2" Pulleys (55) to the two *1"
Plates (75) with 3/8* x 1 3/4* Bolts (26) and
3/8* Nylock Nuts (15). Make sure that the
Pulleys are attached to the holes in the ends
of the "I* Plates.
10