Sears LIFESTULER SYSTEM 40 831.15931 - Manual (Page 13)

33. Attach a Thick 'L" Bracket (100) to the bracket
on the Top Brace (86) with a 5/16" x 3 1/4*
Bolt (19) and 5/16" Nylock Nut (4). Make sure
that the Thick "L* Bracket is turned as shown.
Slide a Plastic Cable Guide (18) and a 3 1/2*
Pulley (55) onto a x 1 ^4* Bolt (26). Insert
the Bolt into the Thick "L" Bracket (100) and
tighten a 3/8" Nylock Nut (15) onto the Bolt.
Pull back the Plastic Cable Guide (18) and
lay the Long Cable (93) over the 3 1/2* Pulley
(55). Turn the Plastic Cable Guide so it holds
the Cable on the Pulley.
34. Slide a Plastic Cable Guide (18) and a 3 1/2"
Pulley (55) onto a 3/8* x 2" Bolt (44). Insert the
Bolt into uie Thin "L* Bracket (99) on the left
Arm (51) and tighten a 3/8" Nylock Nut (15)
onto the Bolt.
Pull back the Plastic Cable Guide (18) and
wrap the Long Cable (93) around the 3 1/2"
Pulley (55). Turn the Plastic Cable Guide so
it holds the Cable on the Pulley.
35. Attach a 3" "U" Bracket (97) to the Front
Upright (76) with a 5/16" x 4" Bolt (27), 5/16“
Washer (10) and 5/16" Nylock Nut (4). The
Nylock Nut should be threaded onto the
Bolt four complete turns. The cabling will
be too short If the Nylock Nut Is overtight­
ened.
Wrap the Long Cable (93) around a 4 1/2"
Pulley (54). Attach the Pulley to the 3* "U"
Bracket (97) with a 3/8" x 1 3/4" Bolt (26) and
3/8" Nylock Nut (15).
36. Slide a Plastic Cable Guide (18) and a 3 1/2"
Pulley (55) onto a 3/8* x 2" Bolt (44). Insert the
Bolt into the Thin "L* Bracket (99) on the right
Arm (51) and tighten a 3/8" Nylock Nut (15)
onto the Bolt. Note: Make sure that the
3 1/2" Pulley Is attached on the side of the
Thin "L" Bracket as shown.
Pull back the Plastic Cable Guide (18) and
wrap the Long Cable (93) around the 3 1/2*
Pulley (55). Turn the Plastic Cable Guide so
it holds the Cable on the Pulley.
33
34
36
15 99
13