Sears LIFESTULER SYSTEM 40 831.15931 - Manual (Page 16)

45. Press a 1“ Round Inner Cap (11) into each
end of the Lat Bar (87).
46. Remove the “HIGH PULLEY“ decal from the
Decal Sheet (not shown). Apply the decal to
the side of the Top Brace (86).
Remove the "DUAL FUNCTION PRESS
ARM" decal from the Decal Sheet (not
shown). Center the decal on the front of the
Arm Support (85).
Remove the "ACTUAL RESISTANCE FOR
BENCH PRESS . . . “ decal from the Decal
Sheet (not shown). Apply the decal to the left
Arm (51).
47. Remove the "VERTICAL KNEE RAISE" decal
from thfi Dfioa! Rhset (not shown) Apply thn
decal to the side of the right VKR Arm (57).
48. Remove the "LOW PULLEY" decal from the
Decal Sheet (not shown). Apply the decal to
the Leg Press Frame (72) below the indicated
3 1/2" Pulley (55).
16
45
46
“HIGH PULLEY
"DUAL FUNCTION
PRESS ARM"
"ACTUAL
RESISTANCE
FOR BENCH
PRESS..."
47
"VERTICAL
KNEE RAISE"
48
"LOW
PULLEY".