Sears LIFESTULER SYSTEM 40 831.15931 - Manual (Page 21)

TROUBLE-SHOOTING AND MAINTENANCE
Inspect and properly lighten all parts of the cross training system each time you exercise. Replace any
worn parts immediately. The cross training system can be cleaned using a damp cloth and mild non­
abrasive detergent. Do not use solvents.
ADJUSTING THE CABLES
If there is too much slack in the cables, the
cables can be adjusted. To tighten the cables,
find the 5/16“ Nylock Nut (4) near the lower end
of the Front Upright (76). To tighten the cables,
hold the 5/16“ x 4" Bolt (27) and turn the Nylock
Nut clockwise. If the cables cannot be tightened
enough by turning the Nylock Nut, see the
instructions below.
Locate the two 3 1/2" Pulleys (55) attached to the
T Plates (75). The "I" Plates have three adjust­
ment holes for tightening the cables. Remove the
3/8" Nylock Nut ( 1 5 ) and 3/8" x 1 3/4" Bolt (26)
attaching the tower Pulley to the 'T Plates. Attach
the Pulley to the next higher hole in the T
Plates. Turn the 5/16" Nylock Nut (4) clockwise
until tne cables are tight (see Drawing i).
If the cables still cannot be tightened enough,
see the back cover of this owner's manual to
order new cables.
21