Sears LIFESTULER SYSTEM 40 831.15931 User Manual
Page 15
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
41. Raise the Weight Selector (82), Place the
remaining nine Weights (79) on the Weight
Guides (83) by tipping the Weights as shown.
Make sure that the Weights are turned so all
of the pin grooves are under the Weights and
are on the same side. Lower the Weight
Selector into the Weights.
42. Open a Weight Sleeve (80) and close it
around one of the Weight Guides (83). Close
the other Weight Sleeve (80) around the
other Weight Guide. Turn the Weight Sleeves
so the hinged sides are toward each other.
43. Tip the top Weight (79) as shown. Fit the low
SiuG
of
the WOiyIli ii ifu
a
Wtsiyi li Sluuve (SO).
Fit the high side of the Weight into the other
Weight Sleeve. Press the Weight and the
Weight Sleeves down until they are resting
on top of the other Weights.
44. Hold the open end of a Weight Sleeve Clip
(81) against one of the Weight Sleeves (80)
as shown. Firmly press the Weight Sleeve
Clip until it snaps around the Weight Sleeve.
Press the other Weight Sleeve Clip (81) onto
the other Weight Sleeve (80) in the same
manner.
42
43
\ V
WWI /
44
15