Sears LIFESTULER SYSTEM 40 831.15931 - Manual (Page 12)

12
29. Attach a 3" *11“ Bracket (97) to the Front
Upright (76) with a 5/16" X 4“ Boit (27), 5/16*
Washer (10) and 5/16* Nyiock Nut (4). The
Nylock Nut should be threaded onto the
Bolt four complete turns. The cabling will
be too short If the Nylock Nut Is overtight­
ened.
Wrap the Long Cable (93) around a 4 1/2“
Pulley (54) as shown. Attach the Pulley to the
3* "U* Bracket (97) with a 3/8* x 1 3/4* Bolt
(26) and 3/8* Nylock Nut (15).
30. Slide a Plastic Cable Guide (18) and a 3 1/2*
Pulley (55) onto a 3/8* x 3 1/2* Bolt (5). Insert
the Bolt into the Leg Lever (71). Slide a 3/8*
Washer (8) onto the Bolt and tighten a 3/8"
Nylock Nut (15) onto the Bolt.
Pull back the Plastic Cable Guide (18) and
wrap the Long Cable (93) around the 3 1/3“
Pulley (55). Turn the Plastic Cable Guide so
it holds the Cable on the Pulley.
31. Slide a Plastic Cable Guide (18) and a 3 1/2*
Pulley (55) onto a 3/8* x 3 3/4" Bolt (21).
Insert the Bolt into the tube on the Base (69)
and tighten a 3/8* Nylock Nut (15) onto the
Bolt.
Pull back the Plastic Cable Guide (18) and
wrap the Long Cable (93) under the 3 1/3"
Pulley (55). Turn the Plastic Cable Guide so
it holds the Cable on the Pulley.
32. Route the Long Cable (93) over the 3 1/2*
Pulley (55) at the lower end of the T Plates
(75).
Slide a Plastic Cable Guide (18) and a 3 1/2"
Pulley (55) onto a 3/8* x 3 3/4* Bolt (21).
Insert the Bolt into the tube on the Front
Upright (76) and tighten a 3/8* Nylock Nut
(15) onto the Bolt.
Pull back the Plastic Cable Guide (18) and
wrap the Long Cable (93) under the 31/3“
Pulley (55). Turn the Plastic Cable Guide so
it holds the Cable on the Pulley.
30
31
¿li