Assembif – Sears 113.24907 User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
assembif
7. The Front Channel should be slightly lower than the
top of the Vertical Channels. Check the height with a
combination square as shown. If it is higher, loosen the
Flange Ntits and lower it.
TOOL HOLDER
1.
Screw a 1-3/4 inch long socket head screw tightly into
each Knob as shown.
2. Screw a Square Nut onto each of the Follower Pins.
NOTE: The Nut has four dots on one side. . .they must
face the threaded end.