Sears 113.24907 - Manual (Page 6)

assembly
MOUNTING COPY-CRAFTER BED TO LATHE
BENCH
1. Remove the Tool Rest Base and locking hardware from
the Lathe (see your Lathe Owners Manual) and place
the
Tailstock approximately 24 inches from the
Headstock. .
NOTE: If your . Lathe has a Tool Rest: Bracket and
locking hardware like the one shown in this illustration,
be sure to unscrew the Threaded Slide and remove it
.. . from the Tool Rest Bracket as shown before mounting
■ the.CopyrCrafter bedi;. / :
remove this threaded slide
FROM THE TOOE BEST BRACKET
before mounting cofy - crafter
2.
3.
Position the Copy-Crafter Bed on the Lathe Bench so
that thé Lathei Bed is between the two. Vertical
Channels of the Copy-Crafter and the Copy-Crafter
label faces the operator.
The front Vertical ChanneTshould be 3-1/4 inches from
the Lathe Bed and 1/2 inch from the foot of the
Headstock as shown.
Check this distance at the other and making sure it is
also 3-1/4: inches. The: Copy-Grafter Bed should now be
parallel to the Lathe Bed.
4.
a.
b.
5,
5.
Without moving the Copy-Crafter Bbd, carefully mark
iocation of 8 bolt holes.
Trace the square portion of the Key Hole at the end
of each Vertical Channel.
Trace the 2 square holes in the center of each
Vertical Channefs, You may have to move the
Taifstock to trace these holes.
Remove the Copy-Crafter Bed and drill 3/8-inch holes
in the center of .the nrtarked squares.
Attach the Copy-Gfafter Bed to the Lathe Bench using
(8} eight Round Head Carriage Bolts, (2) two inches
long and Flange Nuts,
6