Sears 113.24907 - Manual (Page 5)

assembi
BED ASSEMBLY
The Copy-Crafter Bed is made up of (3) three Channels
held together by Tie Rods. All (3) three Channels are the
same except one has the Copy-Crafter label. This is the
Front Channel. The other (2) two are Vertical Channels.
1. Assemble the Front Channel and (1) one of the Vertical
Channels as shown using (2! two Round Head Carriage
Bolts 3/4 inches long and (2) Flange Nuts.
BOUND HEAD BOtTS
AND FLANOE NUTS
VERTICAL CHANNEL
FRONT CHANNEL
7-3/4 INCHES -
2. Screw (2) two Plain Hexagon Nuts and (2) Flange Nuts
an each Tie Rod as shown. The Flange Nuts should be
equal distance from each end of the Tie Rods.
CD
*rl
PLAIN HEXAGON NUT
FLANGE NUT
• EOUAL DISTANCE -
3. Hold the Flange Nut on the end of each Tie Rod with a
1/2 inch wrench or pliers and using another 1/2 inch
wrench, tighten the Plain Hexagon Nut firmly against
the Flange Nut as shown.
4. Lay the Channels on a fiat surface and line up the ends
of the Channels using a combination square as shown.
5. Insert the Tie Rods into the second Key Hole from the
end of each Vertical Channel. The bend in the Tie Rods
should face downward.
6. Move the Tie Rods into the square portion of the Key
Holes.
7. With the Channels still in line, screw a Flange Nut on
the end of each Tie Rod as shown. Tighten the Flange
Nut.
BOTH ENDS SVEN