Sears 113.24907 - Manual (Page 17)

operation
DUPLICATING FROM A TEMPLATE
Here are instructions for two simple projects which will
familarize you with making templates, and then duplicating
from them.
STARTER PROJECT:
GAVEL AND SOUND BLOCK
1. Remove page 15A from this manual and cut with
scissors along dotted lines.
NOTE: The pattern for the handle is full size, however
the overall length of the template must be 13 1/4
inches. Pay particular attention to dimensions of the
ends of the template,
2. Glue the full size patterns to a piece of 1/8 inch or 1/4
inch thick tempered hardboard or plywood. Carefully
cut them out and smooth up the edges with a file.
3. Glue a straight strip of wood to the template to
reinforce it.
SOUND BLOCK
4, The spur center and cup centers of the Lathe should be
in alignment.
If the centers are not in line as shown, make the
following adjustments.
a. Make sure the tailstock and ram are locked when
checking for alignment,
b. Loosen the screw in the foot. . .TAP the screw to
loosen the locknut inside.
c. Using a 3/16" setscrew wrench, loosen the setscrew
on the back of the headstock. The screw is located
about 1-3/4" from the bottom.
d. Swing the tailstock so that the two points are in
line. . .tighten the setscrew in the headstock and the
tailstock.
3/1S" SETSCREW
WRENCH
HEADSTOCK
HANDWHEEL
5. Attach the pattern to the Brackets. The Round Head
Bolts in the top of each Bracket fits into the slot in
each end of the pattern as shown.
6. The centerline of the pattern must be directly in line
with the centerline of the lathe. Use a combination
square to align the centerline of the pattern with the
points of the spur and cup centers as shown. Tighten
the nuts and bolts securing the pattern to the Bracket.
POINT OF
i SPUR CENTER
REINFORCiNQ STRIP
PLAIN HEiCAOON NUTS
AND WASHER
17