Operation – Sears 113.24907 User Manual
Page 20
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
operation
7, Attach Tool Rest (See # 10 page 11} and turn the
workpiece to 4-1/2 inches in diameter.
2 INCH LONG ROUND HEAD BOLT
AMD A PLAIN HEXAGON NUT
8.
Rotate Tool Post 180 degrees and realign the Cutting
Too! with the short Follower Pin; . .screw Knobs into
opposite holes for operation.
NOTE: When turning faceplates, do not move Cutting
Tool to the right of the centerline of the Lathe.
9.
Attach Too! Rest and touch-up corners with the Spear
Point.
.
20