beautypg.com

B.3 a client for snmp management, B.4 console commands that affect the agent, B.5 mib exceptions – Cabletron Systems SmartCell 6A000 User Manual

Page 81: B.5.1 non-conformance, B.5.1

background image

SmartCell 6A000 User Guide Appendix B-5

SmartCell 6A000 and SNMP

A Client for SNMP Management

B.3

A CLIENT FOR SNMP MANAGEMENT

Your SmartCell 6A000 must have a connection to the NMS before it can be managed. The default connection between
the SmartCell 6A000 and the NMS is the SmartCell 6A000 Ethernet interface. An NMS can also manage the SmartCell
6A000 through one of its ATM ports if the SmartCell 6A000 has a client connection into a VLAN or emulated LAN.

Note that the SmartCell 6A000 itself is not reachable through ATM until a client for the switch is created and
participates as a member of a VLAN or ELAN. Your NMS uses the switches client address to access and manage the
switch.

To create a client for the switch, use the

add IPATMClient

command for VLANs, and the

add LANEClient

command

for emulated LANs.

Use the

set MyNmAddr

command to tell the switch which interface to use when communicating with your NMS. For

detailed information about these commands, see the SmartCell 6A000/ZX-250 Reference Manual.

B.4

CONSOLE COMMANDS THAT AFFECT THE
AGENT

The following is a list of the console commands that affect the operation of the SmartCell 6A000 SNMP agent. For
detailed descriptions of these commands, see the SmartCell 6A000 Reference Manual.

Community: Sets the community strings for the switch

TrapCommunity: Specifies the NMS to which traps are sent

MyNMAddr: Sets the address of the interface through which the switch is managed

TrustedNMS:Specifies the IP address of the NMS allowed to manage the switch

B.5

MIB EXCEPTIONS

With the current implementation of MIB files, conformance to ATM standards for the SmartCell 6A000 ATM switch
includes the following exceptions.

B.5.1

Non-Conformance

atmInterfaceIlmiVpi — Read-only

atmInterfaceIlmiVci — Read-only

atmVclLastChange — Always 0

atmVccAalType AAL — Type will be set to 0 if a VCL is internally (not through the NMS)

atmVccAal5EncapsType AAL — Type will be set to 0 if a VCL is internally (not through the NMS)

atmVcCrossConnectL2HLastChange — Always 0

atmVcCrossConnectH2LLastChange — Always 0

aal5VccTable — Returns fake value Waiting for atom2 implementation

atmSvcVcCrossConnectRowStatus Set — Not supported