Cabletron Systems SmartCell 6A000 - Manual (Page 47)

SmartCell 6A000 User Guide 4-13
Switch Administration Setting Up PVC Connections
Figure 4-4 How log and alarm messages are accessed and displayed
4.5 SETTING UP PVC CONNECTIONS
The SmartCell 6A000 supports permanent virtual circuits (PVCs), both point-to-point and point-to-multipoint. Use
PVCs to connect devices that do not support SVCs to a switch's local client or through the switch to form a PVC link
with other devices.
Note The SmartCell 6A000 supports PVCs for IP over ATM only.
Use point-to-point PVCs to connect one end node to another for two-way communication. Use point-to-multipoint
PVCs to connect a broadcast end node to a group of receiving end nodes; traffic is one-way.
Modules & Submodules (SW)
Log Buffer
(Sys Mem)
Log Trace
Buffer
Alarm Message
Buffer
(Flash Mem)
Console
On / Off
No Filter
ing
Filter on
Set Log Alarm Mask
Displays Logs
if set LogPrint is On
One parameter of set LogTrace is Quiet Mode,
which controls whether any Log Messages
are printed, reguardless of filtering.
Displayed by
Show Alarm
command
Filter on
Set Log Trace
Remote
Clients