beautypg.com

Cabletron Systems SmartCell 6A000 User Manual

Page 32

background image

3-4 SmartCell 6A000 User Guide

2.

Create an ELAN on your switch by executing the

add elan

command. The following is an example:

SmartCell ZX # add elan

ELANNumber(0) : 1

use 1 instead of the default, (0)

ELANName(ELAN000) : Marketing

ELAN is named Marketing instead of the default, (ELAN000)

ConnectMethod(SVC):

ELANType(802.3)

< The default (Ethernet) is used

Multipoint(YES) :

MTU(1516) :

Distribute(PROXY) :

SmartCell ZX #

3.

Create a client for the switch on the ELAN. For example, enter

SmartCell ZX # add laneclient

ClientNumber(0) : 1

< one is used instead of the default, (0)

LanName(ELAN001) : Marketing

< ELAN name is Marketing, not the default, (ELAN001)

ServerType(LECS) :

ServerAddress() :

IPAddress() : 90.1.1.1

< IP address and subnet mask is assigned to the client

NetMask(255.0.0.0): 255.255.255.0

MTU(1516) :

SmartCell ZX #

NOTICE - 'ZLESSRV' LES Join 39:00:00:00:00:00:00:00:00:00:14:41:80:00:20:D4:

14:41:82:00

NOTICE - 'ZLESSRV' BUS Connect 39:00:00:00:00:00:00:00:00:00:14:41:80:00:20:D4:

14:41:82:00

Note

When you create a client, it automatically finds the LECS address using ILMI.

Notice that as the newly created client becomes active, messages appear on the console indicating that the client has
registered with the LAN Emulation Server (LES) and the Broadcast and Unknown Sever (BUS).

4.

Enter the

show client

command to make certain that the client is operational.

SmartCell ZX # show client 1

LANE Client 1

============================================================================

Client State : Operational

Client Address : 39:00:00:00:00:00:00:00:00:00:14:41:80:00:20:D4:14:41:81:00

LAN Name : Marketing

LECS Addr Source : ILMI

LECS Address : 39:00:00:00:00:00:00:00:00:00:14:41:80:00:20:D4:14:41:80:01

LES Address : 39:00:00:00:00:00:00:00:00:00:14:41:80:00:20:D4:14:41:82:02

LAN Type : 802.3

MTU : 1516

IP Address : 90.1.1.1

IP NetMask : 255.255.255.0

SmartCell ZX #

Note

While creating an ELAN client for the switch is not absolutely necessary, it does
provide management connectivity with the switch over its ATM ports (instead of
the Ethernet port). See Chapter 4, "Switch Administration."

5.

Physically connect your end nodes and edge devices to the switch ports.