Cabletron Systems SmartCell 6A000 - Manual (Page 22)

2-4 SmartCell 6A000 User Guide
Installing the Switch Switch Installation and Setup
Follow the instructions below to install the switch module into the chassis. Refer to Figure 2-3.
Remove the metal blank that covers one of the empty slots in the chassis.
Open the ejectors at the top and bottom of the switch module.
With the LEDs at the top, align the top and bottom of the SmartCell 6A000 with the tracks in the slot.
Slide the switch into the chassis. The switch module obscures the view of the tracks at the bottom of
the chassis, so be sure to look at that area as you begin to slide the switch into the chassis.
Close the ejectors. The installation is complete.