Philips LP2PB201CS - Manual (Page 17)

STEP3
After confirming the white seiection, the screen will turn into a full white page pat­
tern. Put the Light Probe at the center of the screen and click OK.
NOYE: in case the purpose of the calibration is to match two 21” Cyberscreen ®
displays at different locations, make sure that ambient lighting conditions are simi­
lar. Due to the fact that the calibration probe is slightly sensitive to ambient illumi­
nation, if a monitor is calibrated in a very dark environment while another is cali­
brated when the sun is shining on the screen from the office window you may have
different results.
NOTE: in case the purpose of the calibration is to match two 21” Cyberscreen ®
displays, make sure that settings of both Brightness and Contrast are the same.To
assure that, please take note of the reading of the luminance meter displayed on
the dialog box, below the level bar indicator.___________________________________
STEP3
At this point, the screen will turn into full red page pattern. Put the Light Probe at
the center of the screen and click OK to perform the calibration. The program will
automatically measure and adjust to the proper value the three RGB primary colors
and then the data will be saved into the monitor memory.
10
White color calibration