Philips LP2PB201CS User Manual

Page 12

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

STEP 4 (for Windows)
Connect the cable having the 9 pin D- sub miniature receptacle type connector

(female) to a free RS 232 port of your computer.

STEP 4 (for Apple)

Insert the RS232 Mac adaptor into the Modem port of your Apple PC and then con
nect on it the cable having the 9 pin D- sub miniature receptacle type connector
(female).

NOtE: In case all your serial ports are used, you will be required to temporarily

disconnect a peripheral device to allow the connection of the Light Probe unit.

If this is the case, choose any peripheral other than the mouse since its use will

greatly simplify the use of the Calibration software.
Use the adapter provided with the monitor accessories in case the Light Probe
should be connected to the 25 pole serial port of your PC.._________________________

STEP 5
Connect the other end of the cable to the input port of the Light Probe unit, which is
marked as follows on the bottom of the unit;

STEP 6
Connect the cable of the 21XLP -2 Light Probe unit to the 8 pole Mini Din recepta
cle type connector located on the base unit. Keep the 21XLP -2 Light Probe in its
base housing.

Now that you have installed all the hardware parts of the 21XLP -2 Light Probe
package, you can proceed with the installation of the software.

Getting started