Philips LP2PB201CS - Manual (Page 13)

Install software for Windows
STEP 1: Turn your system on and start the Windows session.
STEP 2: Insert the floppy disk with the 21XLP-2 Light Probe software.
STEP 3: From the Program manager File menu, select Run.
STEP 4: When the Windows dialog box appears, type the letter of the drive the
disk is in, followed by a colon and the word ‘setup’.
Installing the software
example : a ; setup
After a while , a ‘welcome’ box will appear on the screen. Just dick
‘Continue' to proceed with the installation.
Next, another box will be displayed, in which you need to select a dire­
ctory where the installation program wiii install the files.
Default directory is C:\21XLP -2 ; you may change the target directory
by
typing a different one or just dick ‘Continue’.
In the next dialog box you will be requested to tell the program which
serial port of your computer the Light Probe is connected to.
Please check your computer documentation for identification of COM
ports. After this operation, the program will install the Light Probe softwa­
re and, at the end of the installation, a new program group named
Cyberscreen II will be Created in the Program manager window.
This program group contains the calibration program icon labeled 21XLP
_ 2 ; just double dick on this icon to run the Light Probe application.
Install software for Apple
STEP 1 : Insert the floppy disk and double click on the floppy icon
STEP 2: Double click on the Installer Icon and select your language.
STEP 3: The set-up program will create a default folder named “Cyberscreen 11”
and will install all the files on the HD.
STEP 4: Now dick on the 21 XLP _2 icon from the “Cyberscreen II” folder to run
the software
Getting started