Compaq LA36 - Manual (Page 18)

2-6
Paper Handling
Operation Required Conditions *1 Required Action
Ready Printing *2 Fault
Select a resident font — Not printing Off Press Font .
Enter Macro selection mode — Not printing Off Press Macro . ( M1 and M2
will turn blinking
alternately for 3 seconds.)
Select Macro 1 — *4 Off Press M1 within 3 seconds
after pressing Macro .
Select Macro 2 — *4 Off Press M2 within 3 seconds
after pressing Macro .
Switch the protocol — Not printing *4 Off Press Protocol .
Enter Top-of-Form Adjustment mode — Not printing Off Press Set-Up/Quit and Top .
Move paper by 1/60 inch Off — Off Press or button.
Use the adjustment temporarily Off — Off Press Set-Up/Quit .
Use the adjustment permanently Off — Off Press Exit/Save .
Clear the adjustment Off — Off Press Top .
Enter Set-Up mode N/A N/A N/A Turn power on while
pressing Set-Up/Quit .
Move cursor to select Off Not printing Off Press or button.
a Set-Up Function or Value
Move cursor to select
Off Not printing Off Press or button.
a Set-Up Option
Select a Set-Up Function
Off Not printing Off Press or button.
or Value
Select a Set-Up Value and
Off Not printing Off Press Exit/Save .
move cursor to
SAVE&EXIT
Quit Set-Up mode without Off Not printing Off Press Set-Up/Quit .
saving values
Clear software-detected errors
— — Blinking Press Pause .
Initialize the printer — — — Turn power off and on again.
*1 In Normal mode operation, all buttons except Pause are inactive in the Busy state in which the printer is
receiving or printing data.
*2 Not printing includes the following situations: the printer is ready and awaiting data, or the Pause button is
pressed and the printer is awaiting data, or the Pause button is pressed during printing.
*3 This operation is available in the rear-feeding push-tractor mode.
*4 Switching is not done if the printer is holding printing data.