USL LSS-100 - Manual (Page 17)

LSS−100P Installation & Operation Manual
17
The LSS-100P commands and typical responses are shown in figure 19. Note that many of these
commands are commonly used in scripts (described previously), and the lss100.sys.script_run command
can be used to start script execution.
Command Response Description
lss100.sys.auditorium 1 Returns the auditorium number
entered on the configuration
page.
lss100.sys.cct 6255.250284 Returns the correlated color
temperature.
lss100.sys.cdm2 405.151492 Returns the luminance in
candelas per square meter
lss100.sys.comments Conference Room Returns the auditorium
comments entered on the
configuration page.
lss100.sys.ftl 118.332596 Returns the measured luminance
in foot-Lamberts
lss100.sys.spl 83.239520 Returns the measured sound
pressure level in dBc
lss100.sys.temperature 29.2\t84. Returns the internal
temperature in degrees C and
degrees F (separated by tab).
lss100.sys.theater_name USL San Luis Obispo Returns the theater name
entered on the configuration
page.
lss100.sys.theater_number 1 Returns the theater number
entered on the configuration
page.
lss100.sys.ver C\t130522\t120530 Returns the circuit board
version, the firmware version,
and the bootloader versions,
separated by tab.
lss100.sys.xy 0.314743\t0.353419 Returns the chromaticity as x tab
y.
lss100.sys.capture_spl|SPL Center Low|81.2|83.2 83.239520 Instructs the LSS-100P to capture
the current SPL to its log. The
parameters are description, min,
and max. Returns the current
SPL in dBc.
lss100.sys.capture_fl|Luminance|13|15 14.1234 Instructs the LSS-100P to capture
the luminance (measured in fL)
to its log. The parameters are
description, min, and max.
lss100.sys.capture_cdm2|Luminance|47|49 48.4321 Instructs the LSS-100P to capture
the luminance (measured in
cd/m
2 ) to its log. The parameters
are description, min, and max.