Canon Z5000 - Manual (Page 82)

3
3-46 Performing Setup from the Control Panel
Restoring the ColorPASS to factory defaults
When ColorPASS system software is first installed, a backup copy is made
automatically. This backup includes the ColorPASS system software. If the Advanced
Controller Interface option was originally installed, the backup also includes the
Windows NT operating system. You can recover from this backup if necessary without
having to reload the software from CDs.
All job data is cleared when you restore the backup. For information about the items
that are cleared, see “Clearing the ColorPASS.” You must perform Setup again because
the ColorPASS is restored with default settings.
T O RESTORE THE C OLOR PASS:
1. Make sure the ColorPASS is at Idle.
2. Press the Menu button and choose Shut Down.
3. Choose Reboot System.
4. Immediately press the top line selection button and hold it until the diagnostics have
finished.
See “ColorPASS Control Panel” on page 3-3 for the location of the line selection
button. During reboot, a progress bar indicates when the diagnostics have been
completed.
5. Choose Restore Backup.