Canon Z5000 - Manual (Page 40)

3
3-4 Performing Setup from the Control Panel
T O ACCESS S ETUP WHEN THE C OLOR PASS IS AT I DLE :
About the Control Panel Setup interface
When you perform Setup from the Control Panel, you select one menu after another
and enter information about your ColorPASS and your network and printing
environment.
In each Setup screen, the last line of the display window shows the name of the current
Setup menu. Most of the menus you see are shown on the Control Panel Map, a
flowchart that can be printed from the Control Panel.
1. Make sure the information screen on the Control Panel reads Idle.
If Printing or RIPping appears, the ColorPASS is processing, and you must wait
until the system finishes and reaches the Idle state.
2. Press the Menu button on the Control Panel to go to the Functions menu.
3. Scroll with the down arrow and press the line selection button next to Run Setup.
If an Administrator password has been set on the ColorPASS, you are prompted
to enter it before you can perform Setup (see page 3-44).
4. When prompted to confirm your choice, press the line selection button next to OK.
5. Press the line selection button to choose a Setup menu or command.
Press the down button to view the remaining screens of the main Setup menu.
6. Perform, in order, Server Setup, Network Setup, and Printer Setup.
This is the minimum required for initial Setup. Later, you can complete the
remaining Setups either from the Control Panel or from a Windows computer.
7. Set an Administrator password to protect your Setup from unauthorized alteration.
Review the settings described in this chapter. For more information on Control
Panel menus other than those in Setup, see the Job Management Guide.
Exit Setup
Server Setup
Network Setup
Printer Setup
Setup
PS Setup
Color Setup
Job Log Setup
Change Password
Setup